BUG] Additional retract when linear advance is on. · Issue #19982 · MarlinFirmware/Marlin · GitHub

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

32-bit] Extruder no longer steps when Linear Advance is enabled

BUG] (?) Cura 4.11.x and above: Abort prints in Cura / Marlin when

bugfix-1.1.x] Marlin (Linear Advance) produces blobs on 90

Bug in Linear Advance 1.5, causes extruder motor to stop for

BUG] Motor stuttering with linear advance on TMC2208 since Marlin

BUG] Additional retract when linear advance is on. · Issue #19982

BUG] Bulge on linear advance speed change · Issue #16880

BUG] Bulge on linear advance speed change · Issue #16880

BUG] Bulge on linear advance speed change · Issue #16880

Collecting ideas and advises for LIN_ADVANCE v2 · Issue #9048

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

BUG] Rapid changes of acceleration break linear advance when using