Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Arc overhangs print, result and with settings on Bambu studio 1.7.1.62. It's my third test version with 2cm overhangs and I have not optimized my settings. : r/BambuLab

Bambu Lab P1P 3D printer tested extremely fast and precise

Bambu Lab Slicer: Bambu Studio – All You Need to Know

Bambu Lab P1S Desktop Organizer by 3DPrintsAndBeyond - MakerWorld

Why does prusa says that x1 takes 48 minutes to print a benchy? : r/BambuLab

Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C

AMS results for Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

Poor overhang quality - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Bambu Lab Slicer: Bambu Studio – All You Need to Know

AMS results for Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum