USB connection issue with new Mac install - LightBurn Software

They aren’t setting those numbers, that’s just echoing the values stored in the controller. This is how LightBurn knows the maximum: Typing manual S values would require you to be in the correct mode. You’d need to type G1 with a feed rate first, like G1 F100, and then you can use M3 and set an S value. If you aren’t in G1 mode, the S values are ignored because the “spindle” isn’t running during G0 moves, only G1.

Lightburn Setup and Configuration - X-Carve Laser Upgrade

Installing LightBurn on MacOS

Laser cutting software for Mac OS - LaserHints

LightBurn V1.0 GCode License Key –

Operate xTool S1 with LightBurn - xTool Support Center

Troubleshooting Lightburn

Blog - Myers Woodshop

How to Use Lightburn Software: Your First Laser Engraving – OMTech Laser

How to Use Lightburn Software: Your First Laser Engraving – OMTech Laser

4K 8MP IMX219 Autofocus USB Camera Module with Metal Case, 1080P Mini UVC USB2.0 Video Webcam with Microphone, 3.3ft/1m Cable for Computer, Laptop, Raspberry Pi, Jetson Nano-Arducam - Arducam

Thunder Laser Bolt: Download, Install and Configure Lightburn

How to Install LightBurn and How to Switch between LightBurn and EZCAD? : r/Laserengraving

YoraHome 10 Things You Should Know About LightBurn Software - YoraHome Blog