Hotend pauses on print for a few seconds after finish printing

Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!

Random Printing Paused with Filament Sensor Reloaded - Plugins - OctoPrint Community Forum

Reason why my print stops extruding part way through? There is no clog, no break in the filament. Black line in first picture where the printer was when it stopped. : r/ender3

Hotend LOWERS after finishing prints : r/Ender3V3SE

Pause/Resume, Filament Swaps & Sensors

Filaflex vs 'All-metal' hotends - Recreus

3D Printing Troubleshooting Guide

Troubleshooting Jammed Hot End 3D Printer Manufacturers - Airwolf 3D

The 3 Best 3D Printers for 2023

Making Your 3D Printer Pause or Wait with G-Code in Marlin - 3D Print Gorilla

✔️ EXTRA COMPONENTS INCLUDED – In addition to the hotend, this kit comes with a GammaMaster Nozzle (0.4 mm), Mosquito Silicone Boot, & Boron Nitride

Industrial Grade Mosquito Hotend Kit by Slice Engineering | Best Professional 3D Printer Upgrade | Eliminate Heat Creep | Print PEEK & PC | Bimetallic

Extruder jams/clogs up after printing a little bit of filament – Hardware, firmware and software help – Prusa3D Forum

X1/X1-Carbon and AMS Firmware Release History

Retraction: Just say No to oozing

OctoPrint-Autoprint