g code - What Setting In Cura Determines The Value Of G1 E-{switch_extruder_retraction_amount} At The Beginning Of A Print? - 3D Printing Stack Exchange

I am trying to print the Chep calibration cube sliced in Cura on my new Sovol SV04 Dual Extrusion printer. When I print the model the extruder prints the wipe line on the left of the bed, moves to

stacker_s4:add_the_stacker_printer_to_cura [Instructions]

Converting Your 3D printer to a Drawing Machine for Free? - BlazingCold's Blog

New Cura [4.2.1]: Extruder start g-code executed on start · Issue #6160 · Ultimaker/Cura · GitHub

Problems with the start gcode. · Issue #1579 · Ultimaker/Cura · GitHub

marlin - Printer not processing G-code properly? - 3D Printing Stack Exchange

End gcode not fully executing – How do I print this? (Printing help) – Prusa3D Forum

Editing G-Code for Variable Temperature Printing

G-Code generated starts not with Start G-Code inputbox, M80 command Marlin not working /not supported · Issue #5345 · prusa3d/PrusaSlicer · GitHub

4.8.0] Cura puts fails to put T1 code after printer start code and before layer 0 when using 2 extruders and E2 prints first · Issue #8977 · Ultimaker/Cura · GitHub

Why Do My Firmware's Retraction Settings Not Match Cura's Retraction Settings? : r/ender3v2

Beginners Guide to 3D Printing G-Code Commands

Teaching Tech 3D Printer Calibration

Start G-code & End G-code: All You Need to Know

New Cura [4.2.1]: Extruder start g-code executed on start · Issue #6160 · Ultimaker/Cura · GitHub