Prints stuck at layer 2 with Prusa Slicer

I'm having some issues with progress estimates and the displayed current layer does not go past 2. Prints fine. Running RepRapFirmware 3.1.1 but the issue was also present with 2.05 before upgrading Update: The total layer count on this specific print is

Added a modifier to change the print color but it wont change - General discussions - Bambu Lab Community Forum

Prusa Slicer Bridging. How on earth should this work? Instead of bridging the entire top layer, it prints the posts & then tries to bridge (without having a place to attach the

Stuck at preparing infill with only infill where needed enabled 1.41.2 · Issue #1696 · prusa3d/PrusaSlicer · GitHub

Prusa i3 mk3 & mk4 users group, Printer is loud when it moves over large distances or makes a weird noise when doing curvey prints

Building a Prusa I3 3D Printer : 18 Steps - Instructables

PrusaSlicer 2.6 alpha5 stuck at 70% · Issue #10034 · prusa3d/PrusaSlicer · GitHub

X-In/1-Out Non-Mixing Extruder - Automate SuperSlicer & PrusaSlicer Filament Swaps - Configs - Klipper

Performance and verdict - Original PRUSA SL1 review - Page 2

Prusa FINALLY Added Arc Welding Support! PrusaSlicer 2.7