Poor Bed Leveling - Bambu Lab X1-Carbon - Bambu Lab Community Forum

I keep having fluctuations in the adhesion of the prints. Now on the Cool Plate. It went quite well over a few prints. Now the printer is starting to press PLA so hard onto the printing plate again that I can hardly get it off. Is the lidar to blame? Thanks for any suggestions!

Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum

So sick of this $3,000 X1C it's ridiculous - Bambu Lab X1 - Bambu Lab Community Forum

Bambu Labs Printers, [H]ard

Sudden X1C Print Quality Issues - Troubleshooting - Bambu Lab Community Forum

3D Printing - Review - Bambu Lab X1 Carbon 3d printer, Page 2

Bed leveling issues : r/BambuLab

Banding / Ringing type artifacts? - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics - esk8.news: DIY Electric Skateboard Forums

Poor Bed Leveling - Bambu Lab X1-Carbon - Bambu Lab Community Forum