Laser dropouts failure - Snapmaker 2.0 - Snapmaker: where creation happens

Hi all, I try to laser engrave text. The gcode is self-made. Everething looks fine in Luban and Elstam. I engrave from the controller to avoid wifi-problems. Still there are a few lines not printed. It looks they are done with 3%-5% power, like M3 starts too late or the laser is switched off to early. Any ideas? G90 ; absolute Koordinaten G21 ; metrisch M106 P0 S255 ; erster Lüfter auf 100% G0 F1000 ; Geschwindigkeit Leerfahrt G1 F400 ; Geschwindigkeit Arbeitsfahrt M3 P35 S89 ; Laser/Fr

SNAPMAKER 2.0 LASER ETCHING PROBLEM FIXED

Fixing the Filament Run out Error on the Snapmaker 2.0

Dual Extruder - Left feeding gear issue - Snapmaker 2.0

Is digital printing more expensive than screen printing? - Quora

FARR Frameworks(@farr__frameworks) • Instagram写真と動画

October 2022 - Silicon Chip Online

Laser Module Setup Failed - Snapmaker 2.0 - Snapmaker: where

Laser engraving & cutting acrylic and Plexiglass with a laser CNC

Laser cut not in sync with movement (starts cutting late